UNIT CONVERTER / Density Converter

Density Converter

Convert kg/m³ and g/cm³ when transferring material density data into engineering calculations.

Inputs

Updates as you type

Results

kg/m³

7,850kg/m³
Results
g/cm³7.85 g/cm³

Overview

Convert kg/m³ and g/cm³ when transferring material density data into engineering calculations. Use it to turn g/cm³ values from material tables or fluid data into the kg/m³ used for pipe and steel weight calculations.

Formula

1 g/cm³ = 1,000 kg/m³
kg/m³ = g/cm³ × 1,000

Example

7.85 g/cm³ equals 7,850 kg/m³. A density of 1,000 kg/m³ equals 1 g/cm³. Aluminum at 2.7 g/cm³ is 2,700 kg/m³, and diesel at about 0.84 g/cm³ is 840 kg/m³. Water is about 1,000 kg/m³ = 1 g/cm³.

How to use

  1. Enter material density and select kg/m³ or g/cm³ as the input unit.
  2. Read the equivalent density in both units.
  3. For pipe mass, use pipe material density in kg/m³, not the contained fluid density.

Engineering notes

  • Specific gravity is a dimensionless ratio, not a density unit.
  • Temperature effects and material properties are not estimated. Enter the density from your specification.
  • g/cm³, kg/L and t/m³ share the same number: 1 g/cm³ = 1 kg/L = 1 t/m³ = 1,000 kg/m³.
  • The density fields in the steel weight and pipe weight calculators take kg/m³. Entering a g/cm³ value there makes the result 1,000 times too light.

Frequently asked questions FAQ

Is a specific gravity of 7.85 identical to a density of 7.85?

Check the density unit and reference conditions. Density equals specific gravity multiplied by the reference density.

Does it convert lb/ft³?

No. 1 lb/ft³ ≈ 16.0185 kg/m³, so convert to kg/m³ and enter that.

How much does fluid density change with temperature?

It depends on the fluid. Water changes little around room temperature, but fluids such as fuel oil change noticeably. Take the density at the relevant temperature from the specification or test data.

KEEP WORKING

Enter the converted material density in kg/m³ into the pipe weight calculator. For a steel pipe, use steel density rather than the contained fluid density. Compare mass or volume units with the corresponding converters.