ENGINEERING NOTES

Engineering guides

Understand the assumptions, input requirements and meaning of your calculation results.

01Piping / GUIDE

Pipe Weight Calculation: Formula and Example

Calculate pipe metal area, kg/m and total mass from OD, wall thickness, length and density, with a carbon-steel example and practical quantity checks.

Read guide
02Piping / GUIDE

NPS, DN and OD: Nominal Size vs Actual Dimensions

Distinguish NPS and DN size labels from actual outside diameter, understand NPS 2 and DN 50 notation, and avoid inch-to-mm errors before calculation.

Read guide
03Piping / GUIDE

Pipe Schedule and Wall Thickness Explained

Understand SCH 10, 20, 40 and 80 as wall designations, and compare how a thicker wall affects bore, kg/m and internal volume without assuming a pressure rating.

Read guide
04Piping / GUIDE

Pipe Internal Volume: Calculate m³ and Litres

Calculate pipe bore area and fluid hold-up from OD, wall and length, with a worked example and practical filling, draining and flushing limitations.

Read guide
05Piping / GUIDE

Pipe Flow Velocity: Flow Rate, Area and Example

Use v = Q/A with actual internal diameter, convert m³/h and L/min to SI flow, and understand why a smaller bore raises velocity at the same flow rate.

Read guide
06Marine / GUIDE

Draft, Mean Draft and Trim: A Worked Guide

Understand forward and aft draft, the two-point mean and signed trim, using FWD 7.8 m and AFT 8.5 m while separating geometry from hydrostatic assessment.

Read guide
07Marine / GUIDE

Trim by Stern vs Trim by Bow: Signs and Diagram

Read positive, negative and zero trim from forward and aft draft, with three worked cases, a simple vessel diagram and sign-convention checks.

Read guide
08Marine / GUIDE

Tank Volume and Fill Percentage: Two Examples

Calculate total, liquid and remaining volume for rectangular and vertical cylindrical tanks, convert to litres, and distinguish ideal geometry from calibrated capacity.

Read guide
09CAD / GUIDE

AutoCAD Scale Factor: 1:100 to 1:50

Calculate drawing-scale conversion factors, check the 100/50 = 2 example, and distinguish rescaling geometry from model-space, viewport and paper-space settings.

Read guide
10Unit Conversion / GUIDE

mm and Inch Conversion: Decimal and Fractional

Convert with exactly 25.4 mm per inch, understand decimal and fractional inches through 1/64, and check rounding error without confusing pipe nominal size with OD.

Read guide
11Marine / GUIDE

Horizontal Tank Volume: Why Liquid Height and Capacity Are Not Proportional

Calculate liquid volume and fill of a horizontal cylindrical tank from the liquid height with the circular-segment formula, head volumes and a dip table, using a worked example.

Read guide
12Unit Conversion / GUIDE

Gauge and Absolute Pressure: Reading bar, psi and kgf/cm²

Understand barg versus bara and psig versus psia, how to add or remove atmospheric pressure, and how bar, psi, kgf/cm² and MPa convert, with worked examples.

Read guide
13Piping / GUIDE

Hydrotest Water Volume: Internal Volume and Water Weight

Calculate the water needed for hydrotests and flushing from pipe bores, and the weight of water-filled pipe for support checks, with a worked example.

Read guide
14Marine / GUIDE

Tank Sounding, Ullage and Reading Calibration Tables

Learn the difference between sounding and ullage, convert ullage to liquid height, interpolate calibration tables, and calculate consumption and mass with rectangular and horizontal tank examples.

Read guide
15Piping / GUIDE

Steel Weight Calculation: Weight per Meter of Plate, Round Bar and H-Beams

Calculate cross-sectional area and unit weight of plate (kg/m²), round bar, H-beams and angles with formulas and worked examples, and see why results differ slightly from section tables.

Read guide