Marine
Check draft and trim readings and calculate liquid volume in rectangular, vertical and horizontal tanks.
Draft and Trim Calculator
Get the mean draft, signed draft difference and trim direction from forward and aft drafts, plus gradient and angle when a reference length is given.
Open calculatorRectangular Tank Volume Calculator
Calculate total capacity, liquid volume, remaining volume and fill percentage for a rectangular tank.
Open calculatorCylindrical Tank Volume Calculator
Calculate capacity and current liquid volume for a vertical, flat-bottomed cylindrical tank.
Open calculatorHorizontal Tank Volume Calculator
Calculate liquid volume and fill percentage of a horizontal cylindrical tank from the liquid height, with flat, hemispherical or 2:1 ellipsoidal heads.
Open calculatorWhat this section covers
Basic calculations for ship operation and tank management: mean draft and trim from forward and aft drafts, and liquid height to volume for rectangular, vertical cylindrical and horizontal cylindrical tanks.
Every result is a geometric, theoretical value. For a real ship's displacement, stability and tank calibration, approved hydrostatic data and sounding tables take precedence; use these results to review those values or check them approximately.
Which tool should I use?
- Draft and Trim Calculator — See mean draft, draft difference, trim direction and angle from forward and aft drafts
- Rectangular Tank Volume Calculator — Turn a rectangular tank's sounding into volume and fill
- Cylindrical Tank Volume Calculator — See the contents of an upright cylindrical tank and the volume per centimeter
- Horizontal Tank Volume Calculator — Turn the liquid height of a tank lying on its side into volume, heads included
Common mistakes
- Reading the trim sign backwards: this site uses AFT − FWD, so positive means trim by stern.
- Using the vertical-cylinder formula for a horizontal tank: at 40% of the diameter the tank is only about 37% full.
- Entering ullage (the empty height) as the liquid height: subtract it from the reference height first.
Related guides
- Draft, Mean Draft and Trim: A Worked Guide — Understand forward and aft draft, the two-point mean and signed trim, using FWD 7.8 m and AFT 8.5 m while separating geometry from hydrostatic assessment.
- Trim by Stern vs Trim by Bow: Signs and Diagram — Read positive, negative and zero trim from forward and aft draft, with three worked cases, a simple vessel diagram and sign-convention checks.
- Tank Volume and Fill Percentage: Two Examples — Calculate total, liquid and remaining volume for rectangular and vertical cylindrical tanks, convert to litres, and distinguish ideal geometry from calibrated capacity.
- Horizontal Tank Volume: Why Liquid Height and Capacity Are Not Proportional — Calculate liquid volume and fill of a horizontal cylindrical tank from the liquid height with the circular-segment formula, head volumes and a dip table, using a worked example.
- Tank Sounding, Ullage and Reading Calibration Tables — Learn the difference between sounding and ullage, convert ullage to liquid height, interpolate calibration tables, and calculate consumption and mass with rectangular and horizontal tank examples.